Epson S020047, S020049 & S020097 Cartridges Refilling instructions for Epson Color II / IIS, 200, 500, 850 and 1500 printers.
Black & Color Cartridges
1. Use a piece of adhesive tape to seal each outlet hole(s) in the base of the cartridge. It is recommended to use a separate piece over each hole.
2. Using a small (1/8" / 3mm) drill make breather holes in positions shown below. This is not necessary on black cartridge.
3. Attach the needle to the syringe with the appropriate color ink.
4.Using the needle, push through the label all the way into the cartridge of the correct filling hole. Very slowly inject ink into the sponge until the cartridge is full. This will soak the sponge with ink and refill the reservoir.
5. Seal the breather hole(s) with the included plugs or adhesive tape. Note: The cartridge will leak if the breather holes are not sealed properly.
6. Any unused ink may be returned to the bottle. Rinse the syringe with water and dry between each color refilling or store for further.
7. Reinsert the cartridge leaving the tape on the outlet holes and run cleaning cycles as per printer instructions. If necessary leave for up to 24 hours to allow the ink to flow to the print head.
NOTE: If cartridge is refilled before it is completely empty this time is greatly reduced.
For extra syringes, needles or other tools please see our accessories page.
|
|